Brinkmann Smoker owner manual Step

STEP 1:

a.Attach wooden handle halves to metal brackets using 8-32 x w" screws and nuts as illustrated.

b.Attach two handle assemblies to side of smoker body using 10-24 x s" screws and nuts as illustrated.

c.Attach three support brackets to inside of smoker body through the

three 4" holes that are located about halfway down the smoker body (lower level). Mount each bracket with notched side facing up using 10-24 x s" screws and square nuts. Tighten screws securely.

d.Attach remaining three support brackets to inside of smoker body through the three 4" holes located near the top edge. Mount each bracket with notched side facing up using 10-24 x s" screws and square nuts. Tighten screws securely.

STEP 2:

a.Attach hinge to inside of smoker body as illustrated. Use

6-32 x 4" screws and nuts to attach hinge to smoker body.

NOTE: Attach the hinge so pin is facing out of smoker as illustrated.

b.Attach door to hinge using the remaining 6-32 x 4" screws and nuts.

Bracket with notched side facing up.

Pin Facing Out

4