ASSEMBLY STEPS
Most Charmglow® grill models will use motor mount bracket 4 (Step 1 - Step 6), if your grill is model
5and skip to Step 7.
Step 1
Open grill hood and remove cooking grills. Refer to your original grill owner’s manual.
Step 2
Attach motor mount bracket 4B on the left hand side of the grill using two screws, washers and nuts.
Note: Motor mount bracket 4B may be flipped to fit properly on certain grills.
Step 3
Attach motor mount bracket 4A to bracket 4B using one screw as shown. Keep screw loose until height adjustment has been set.
Step 4
If a notch on the right side of the grill does not exist for your spit rod, attach the spit rod support bracket to the outside right hand side of the grill using two screws, washers and nuts. (Two sets of holes are provided depending on your grill model.)
Step 5
Using a combination of sections, securely assemble the spit rod to a length that will rest on both the motor mount bracket to the spit rod bracket.
Step 6
To set the proper height for your motor mount bracket, place the motor on the motor mount bracket, place the spit rod in the motor and slide the bracket adjustment up or down until the spit rod is level. After adjustment has been made, tighten motor mount bracket 4A to bracket 4B with screw.
Motor Mount
Bracket 4A
Motor Mount
Bracket 4B
Right Support |
Bracket |
3