Installation:LapBeltOnly

IMPORTANT: Before installing the Expressway in your vehicle, make sure that the shoulder slots are at the correct level for your child. See "Checking Harness Height" on page 6).

1 Place the Expressway facing forward on the vehicle seat and pull the harness tight.

2 Pass the seat belt through both side slots and fasten buckle. (See Figure B)

3 Before continuing, make sure that the lap belt passes through BOTH lower lap belt positioning guides. (See Figure B)

This is a typical lap seat belt

configuration.

A

Installation:LapBeltOnly

4 With one hand, push the child seat down into the vehicle seat cushion, while tightening the seat belt with the other. (See Figure C)

5 Verify that the seat belt is tight and the child seat is secure.

See "Checking Buckle Position" C on Page 20.

To remove your Expressway, unfasten the seat belt and reverse the above directions.

IMPORTANT: When the ISOFIT Connectors are not in use, they must be securely connected to the tie wraps located under the D cover on each side of the child seat. (See Figure D)

B

16

17