CheckingHarnessHeight
The shoulder harness MUST be threaded through the slots in the cover and shell nearest the top of your child’s shoulders. If in any doubt always use the slot above the shoulder rather than below it.
Once the top slots become necessary, your child may continue to use the seat until the center of the ears become level with the top of the seat shell or weight exceeds 40 lbs.
Adjusting Harness Height
1 Remove the soft pads by releasing the hook and loop fastener connection.
2 Loosen the harness by pushing the harness release button while pulling the shoulder straps forward as far as possible. Use the pull rings to aid in loosening the A harness. (See Figure A)
6
Adjusting Harness Height
3 From rear of seat, remove c- |
| |
clips from HUGS straps. (See |
| |
Figure B) |
| |
4 Unhook the shoulder straps |
| |
from the yoke. (See Figure C) |
| |
5 Pull all straps through the shell |
| |
and cover, to the front of the |
| |
seat. | B | |
6 Thread the harness straps |
| |
through the appropriate harness |
| |
height slots. (See Figure D) |
| |
7 Reattach harness straps to the |
| |
yoke. (See Figure C) |
| |
8 Pull harness adjuster strap to |
| |
tighten the harness. |
| |
9 Thread HUGS straps over the | C | |
harness straps and through the | ||
| ||
same slot as the corresponding |
| |
harness strap. |
| |
10 Reattach a |
| |
at the end of the HUGS straps. |
| |
(See Figure B) |
| |
11 Pull HUGS down as far as it |
| |
will go and verify that all straps |
| |
are threaded at the same height | D | |
and are not twisted. |
|
7