Checking
Buckle
Position
NOTE: This section does not apply when
ISOFIT is used.
The position of the vehicle belt buckle can affect the stability of your Expressway. In an accident this could prevent your Expressway from protecting your child as well as it should.
If, when the lap belt is properly tightened, the buckle lies in the position marked as wrong ( 
), then try moving the Expressway to another seating position in your vehicle.
If it is not possible to achieve the correct position for the buckle, then another seating position MUST be used.
Using the Chest Clip
NOTE: The appearance of the chest clip may vary.
Open the chest clip by squeezing the middle tab(s).
IMPORTANT: The correct height for the chest clip is at the middle of the chest, level to the armpit. Always make sure that the harness is tight before each use or after any adjustments.
Using the Puzzle Buckle
If the buckle's tongues cannot be inserted properly (if click is not heard), press the red button on the buckle to release, then
Periodically clean the buckle to ensure proper operation. Refer to "Cleaning the Buckle" on page 26 for instructions.
Using Recline Positions
The Expressway has a choice of two positions for your child's comfort. It can be used in either awake or sleeping position. Both are tested and approved.
Pull the recline release handle, then slide the base of the seat into the desired position. Let go of the release handle and be certain that your Expressway has locked into place.
Awake | Sleeping |
20 | 21 |