A box or similar stand approximately 11” high x 15” long x 7” wide is recommended for power pack removal. The box must be able to support 60 lbs. or more since you will be placing the full weight of the power pack on it.
1.Unplug compactor from socket.
2.Remove drawer assembly from cabinet.
3.Remove Air Scentry tray and control panel.
4.Remove key switch control bracket assembly. Remove back panel.
5.Place box in cabinet and lower ram manually by turning 15/ 16" nut on sprocket clockwise. Box should support weight of power pack.
6.Remove the four 5/16" nuts supporting the power pack in the cabinet.
7.Disconnect ground wire attached to cabinet.
8.Turn 15/16" nut counterclockwise causing power pack to lower down out of cabinet. Pull power pack out through front of rear of compactor.
If you are replacing the cabinet, remove remaining parts from old cabinet and install on new. See appropriate sections of service manual.
Reverse procedure to install power pack. Be sure the weld strip, grommets, and spacers are in place. The lock nuts should be torqued to 5 ft./lbs. (60 inch/lbs.). Do not overtorque.
Be careful not to pinch or nick any wires when installing power pack in cabinet.
|
|
|
|
|
|
WELD | STRIP | GROMMETS | |||
|
| SPACERS | |||
|
|
|
| ||
POWER PACK
MOUNTING
LOCK NUTS
CONTROL PANELOn units with a bag storage compartment, removal of the storage compartment will make replacement of the control panel easier.
1.Remove drawer assembly.
2.Remove the four screws securing the air scentry tray and the bottom of control panel to the cabinet.
3.Pull bottom of control panel out slightly and then up.
When installing the control panel, make sure lip on inside of control panel snaps behind the bend in the control panel bracket.
STORAGE COMPARTMENTRemove two screws on rear of compactor and the two 5/16" hex head screws inside the storage compartment. Slide compartment back and lift off.
1.Pull out drawer until it stops.
2.Lift drawer slightly, then pull out drawer to second stop.
3.Lift drawer up and out of compactor.
FOOT PEDAL (MODELS 1050 & 1051 ONLY)
1.Remove foot pedal retainers from each side of pedal.
2.Push foot pedal hinge pin out, catch foot pedal spring as it comes free.
DOOR LINERRemove the door from the drawer by unlatching the door and removing the hinge pins. The door liner can be removed from the door by removing the toe space cover and all screws holding the door liner to the door. Slide the door liner to side of door and lift off. (Models 1050 and 1051 will require removal of the foot pedal prior to toe space cover.)
DRAWER AND BASE ROLLERSAll four of the rollers are secured with a 1/2" hex nut and slotted for screwdriver. Roller nuts are installed using LocktiteR and torqued to 20 foot pounds. Rollers are pregreased and should require no lubricant.
BOTTOM ASSEMBLY1.Unscrew level legs from base. Remove tee nuts that legs screw into.
2.Remove screws securing bottom assembly to the cabinet.
3.Lower the bottom down into the cabinet, back end first, then bring it up and out through the notches in the bottom flange of the cabinet.
5