Broan 637004 manual Operation, Halogen Bulbs, Controls, Heat Sentry

OPERATION

Controls

The hood is operated using the slide controls under the front edge of the hood.

The light switch turns the halogen lights on and off.

The blower on / off switch turns the blower on to the running speed set by the blower speed control. The blower must be turned on and off using this switch.

LIGHT		BLOWER
SWITCH	BLOWER	ON / OFF
		SWITCH
	SPEED
	CONTROL

PILOT

LAMP

The blower speed control changes the running speed of the blower (1-2-3). The pilot lamp lights up whenever the blower is on.

HEAT SENTRY™

Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.

1)If blower is OFF - it turns blower ON to HIGH speed.

2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed. When the temperature level drops to normal, the blower will return to its original setting.

WARNING

The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.

HALOGEN BULBS

This range hood requires 4 halogen bulbs (Type JC, 12Volt, 20Watt Max, G-4 Base).

ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.

To change bulbs:

1.Loosen the ring nut by turning it counterclockwise.

2.Pull the bulb downwards to remove - DO NOT ROTATE. CAUTION: BULB MAY BE

HOT!

3.Replace with Type JC, 12Volt, 20Watt Max, G-4 Base halogen bulb. Do not touch replacement bulb with bare hands!

RING NUT

- 10 -