Control panel message

Description

 

Recommended action

 

 

 

 

 

MANUALLY FEED <TYPE> <SIZE>

No media is in tray 1, and a print job requires

Press

to print from another tray. See Load

alternates with

 

a specific type and size that is available in

input trays on page 19 for more information.

 

another tray.

 

or

 

 

To use another tray press

 

 

 

 

 

 

 

 

 

 

 

 

 

Press

for help.

 

 

 

 

MANUALLY FEED OUTPUT STACK

The first side of a manual two-sided print job

Take the printed stack out of the output bin

alternates with

 

has been printed and the device is paused

and reinsert it in tray 1 to print the second side

 

until for the output stack is reinserted.

 

of the two-sided print job. Press

to

Then press

to print second sides

 

 

continue.

 

 

 

 

 

 

 

 

 

 

MEM TEST FAILURE REPLACE DIMM 1

The memory DIMM has failed.

 

Install a supported memory DIMM. See Install

 

 

 

 

memory on page 26.

 

 

 

 

 

NON HP SUPPLY IN USE

The device has detected that a non-

 

If you believe you purchased an HP supply,

alternates with

 

HP supply is currently installed but

was

go to www.hp.com/go/anticounterfeit.

 

pressed to override the message.

 

 

 

 

Service or repairs that are required as a result

Readyof using non-HP supplies are not covered under HP warranty.

NON HP SUPPLY INSTALLED

A new, non-HP supply has been installed.

If you believe you purchased an HP supply,

alternates with

This message appears until an HP supply is

go to www.hp.com/go/anticounterfeit.

installed or you press .

Service or repairs that are required as a result

 

 

For help press

 

of using non-HP supplies are not covered

 

 

under HP warranty.

 

 

To continue printing, press .

 

 

 

PAPER PATH JAM FRONT DOOR

A page is jammed in the paper path.

Open the front door and remove any jammed

alternates with

 

media.

 

 

 

 

For help press

 

 

 

 

 

 

Paused

The device has paused.

Press Stop to resume printing.

alternates with

 

 

 

To return to Ready press the STOP key

 

 

 

 

 

 

Performing upgrade

A firmware upgrade is in process.

No action necessary. Do not turn off the

 

 

device.

 

 

 

 

 

PRINTING STOPPED

This message appears when a Print/Stop test

Press

to continue printing.

To continue press

runs and the time expires.

 

 

 

 

 

 

 

 

PROCESSING DUPLEX JOB

During duplex printing, the paper emerges for

Do not pick up pages until they come to rest

alternates with

a short time before it is pulled back into the

in the output bin.

device.

 

 

Do not grab paper until job completes

 

 

 

 

 

 

RAM DISK DEVICE FAILURE

The RAM disk has failed.

Printing can continue for jobs that do not

alternates with

 

require the RAM disk.

 

To remove this message from the display,

Ready

 

 

press .

 

To clear press

144 Chapter 6 Troubleshooting

ENWW

Page 162
Image 162
HP P3005 manual Manually Feed Output Stack, MEM Test Failure Replace Dimm, NON HP Supply in USE, NON HP Supply Installed