HP P3005 manual Check Dimm installation, Verify that Dimm is installed correctly

9.To replace the right side panel, line up the alignment arrows and slide the panel toward the front of the device until it latches into place.

10.Reconnect the interface cable(s) and the power cord.

11.Turn the device on.

Check DIMM installation

After installing the DIMM, make sure that the installation was successful.

Verify that DIMM is installed correctly

1.Turn the device on. Check that the Ready light is illuminated after the device has gone through the startup sequence. If an error message appears, a DIMM might have been incorrectly installed. See Control-panel messages on page 131.

2.Print a configuration page (see Use information pages on page 38).

3.Check the memory section on the configuration page and compare it to the configuration page that was printed before the memory installation. If the amount of memory has not increased, the DIMM might not be installed correctly, or the DIMM might be defective. Repeat the installation procedure. If necessary, install a different DIMM.

NOTE If you installed a device language (personality), check the "Installed Personalities and Options" section on the configuration page. This area should list the new device language.

ENWW Install accessories 29