HP P3005 manual Gear assembly, 41Removing the gear assembly 1 Removal and replacement

Gear assembly

1.Remove the following components:

●All covers (see Covers on page 69)

●Formatter (see Formatter on page 80)

●ECU (see Engine control unit (ECU) on page 88)

●High-voltage power supply (see High-voltage power supply on page 97)

2.Remove the two switch link assembly screws (callout 1), slide the assembly toward the front of the device, and then lift it out of the device.

3.Remove three cables from the cable guides (callout 2).

NOTE Make sure that you duplicate the cable routing upon reinstallation.

2

1

Figure 5-41Removing the gear assembly (1 of 3)

108 Chapter 5 Removal and replacement ENWW