Control panel message | Description | Recommended action | ||
|
|
| ||
RAM DISK FILE OPERATION FAILED | The device received a PJL file system | Printing can continue. | ||
alternates with | command that attempted to perform an | To remove this message from the display, | ||
illogical operation (for example, to download | ||||
Ready | a file to a | press | . | |
|
|
|
| |
To clear press |
| If the message reappears, there might be a | ||
| problem with the software program. | |||
|
|
| ||
RAM DISK FILE SYSTEM IS FULL | The device received a PJL file system | 1. Use HP Web Jetadmin software to | ||
alternates with | command to store something on the file |
| delete files from the RAM disk memory | |
system, but the file system is full. |
| and try again. | ||
Ready |
| 2. To remove this message from the | ||
To clear press |
|
| display, press . | |
|
|
|
| |
|
|
| ||
RAM DISK IS WRITE PROTECTED | The file system is protected and no new files | 1. To enable writing to the RAM disk | ||
alternates with | can be written to it. |
| memory, use HP Web Jetadmin to turn | |
|
| off write protection. | ||
Ready |
| 2. To remove this message from the | ||
To clear press |
|
| display, press . | |
|
|
|
| |
|
|
| ||
Receiving upgrade | A firmware upgrade is in progress. | Do not turn the device off until the device | ||
|
| returns to Ready. | ||
|
|
| ||
Replace supply | The print cartridge is out and needs to be | Install a new cartridge. For more information, | ||
alternates with | replaced. | |||
|
|
|
| |
For status press |
|
|
|
|
|
|
| ||
Resend upgrade | The firmware upgrade was not successful. | Attempt the upgrade again. | ||
|
|
|
| |
RFU LOAD ERROR | An error has occurred during a firmware | 1. | Reinstall the firmware. | |
| upgrade. | 2. | If the problem persists, contact | |
|
| |||
|
|
| HP Support. | |
|
|
| ||
SIZE MISMATCH IN TRAY XX | The tray is loaded with a media size that is | 1. Make sure the media guides are | ||
alternates with | different than the size for which the tray is |
| adjusted correctly. | |
configured. Printing can continue from other | 2. In the PAPER HANDLING menu, | |||
Ready | trays, but not from this one. | |||
|
| configure the tray for the correct size. | ||
|
|
| ||
Sleep mode on | The device is in Sleep mode. Any button | No action necessary. The device | ||
| press or the receipt of data clears Sleep | automatically exits Sleep mode. | ||
| mode. |
|
|
|
|
|
| ||
STANDARD TOP BIN FULL | The | 1. Empty the output bin. Printing resumes | ||
alternates with | that the bin is full. |
| automatically. | |
| 2. | If the problem persists, verify that the | ||
Remove all paper from bin |
| |||
|
| connector at sensor PS4 is fully seated. | ||
|
|
| The other end of the wiring is | |
|
|
| to the ECU. | |
|
|
| ||
Tray X <TYPE> <SIZE> | The device is reporting the current | No action necessary. | ||
alternates with | configuration of tray X. | Press | to clear the message. | |
| ||||
To change size or type press |
| Press | to change the type or size. | |
|
|
|
|
|
ENWW |