Control panel
1.Remove the following components:
●
●Top, right cover (see Top, right cover on page 73)
●Front, right cover (see Front, right cover on page 75)
2.Remove the grounding wire over the fan assembly (callout 1), disconnect one cable (callout 2) on the formatter, and then remove one grounding screw (callout 3).
1
3
Figure
3.Lift the control panel off of the device.
2
Reinstallation tip To reinstall the control panel correctly, use the locator pin (callout 4) and place the sheet metal front of the control panel assembly (callout 5) in front of the device chassis.
78 Chapter 5 Removal and replacement | ENWW |