HP P3005 manual Packet Size

3.Print a configuration page to verify that the I/O card is ready (see Use information pages on page 38). An HP Jetdirect configuration page also will print.

4.On the HP Jetdirect configuration page, confirm the following settings:

●Under HP Jetdirect Configuration, the status us “I/O Card Ready”.

●The status is “Ready”.

●An IP address is listed.

●The configuration method (Config by:) is listed correctly. See the network administrator if you are not sure which method is correct.

●The domain name is listed correctly.

5.Perform a ping test to verify that the device is communicating with other devices on the network.

a.Press Menu.

b.Use to select CONFIGURE DEVICE, and the press .

c.Use to select I/O, and the press .

d.Use to select EMBEDDED JETDIRECT MENU, and the press .

e.Use to select DIAGNOSTICS, and the press .

f.Use to select PING TEST, and the press .

g.Set the following menu items

●DEST IPv4: Type the IP address from the configuration page.

●PACKET SIZE: 64

●TIMEOUT: 1 second

●COUNT: 4

●PRINT RESULTS: YES

●EXECUTE: YES

The ping test starts automatically after the EXECUTE setting is set. If the test was successful, a page that shows the ping test results will print.

6.Print the job from another computer.

7.To verify that the device works with a computer, connect the device directly to the computer. You will have to reinstall the printing software. Print a document from a program that has printed correctly in the past. If the job prints, a problem with the network might exist.

ENWW Interface troubleshooting 159