MODEL 778WH
Page 3
ADDITIONAL
MOUNTING
HOLES
5.Additional mounting holes are provided for installations where access from above is inconvenient or not possible. Nail or screw housing directly to joists or framing.
INSTALL THE DUCTWORK
FLUSH
1.Snap the damper/duct connector onto housing. Make sure that tabs on the connector lock into slots in housing.Top of damper/duct connector should be flush with top of housing.
2.Connect 4” round duct to damper/duct connector and extend duct to outside through a roof or wall cap. Check damper to make sure that it opens freely. Tape all duct connections to make them secure and air tight.
CONNECT THE WIRING
SCHEMATIC WIRING DIAGRAM
L I G H T | R E D | B L U L I G H T W H T | |||||
S W I T C H |
|
|
|
| ( W H I T E ) | ||
V E N T |
|
| B L K | B L K V E N T W H T | |||
S W I T C H |
|
|
| ||||
|
|
|
| ( B L A C K ) | |||
| B L K |
|
|
|
| ||
|
|
|
|
| |||
L I N E |
|
|
|
|
| W H T |
|
W H T |
| ||||||
I N |
|
|
|
|
|
|
|
G R D | G R D |
| |||||
|
| ||||||
|
| S W I T C H B O X |
| U N I T |
ATTACH THE GRILLE PAN AND GLASS SHADE
GRILLE | GRILLE |
PAN | SCREW |
WASHER
ROD | COLLAR |
GLASS SHADE | WASHER |
| 13 WATT |
| MAX. |
| GU24 BASE |
| FLUORESCENT |
| BULBS |
GRILLE | WASHER (2 REQ.) |
PAN | ROD |
| |
| STEEL |
| WASHER |
GLASS | FELT |
SHADE | WASHER |
| (Add second |
| washer as |
| needed to |
| secure shade |
| tightly.) |
FINIAL | FELT |
NUT | WASHER |
1. | Locate the grille pan over the fan housing and connect the |
| wiring harness plug into white receptacle in the fan housing. |
2. | Insert rod through center hole of grille pan. Use washer |
| between collar on rod and pan. |
3. | Thread rod onto grille screw in housing, until pan is tight |
| against ceiling. Do not |
DUAL CONTROL
(purchase separately)
LIGHT
FAN
BLACK | RED | WHITE |
RECEPTACLE | ||
WHITE | GROUND | (LIGHT) |
BLUE | (bare) | BLACK |
| ||
|
| RECEPTACLE |
SWITCH BOX |
| (FAN) |
WIRING
PLATE
120VAC LINE IN
4. | Install bulbs.Use |
| bulbs. |
5. | Place washers and glass shade over mounting rod and align |
| shade onto grille pan. Secure glass shade to grille pan with |
| felt washer(s) and finial nut as shown. |
6. | Restore electrical power and check operation of the unit. |
1.Wire unit following diagram above. Run electrical cable as direct as possible to unit. Do not allow cable to touch sides or top of unit after installation is complete.