OPERATION |
|
|
|
| LIGHT | BLOWER | |
|
| ||
Controls |
| SWITCH | |
| SWITCH | ||
The hood is operated using the slide controls |
|
| |
|
| PILOT | |
under the bottom of the hood. |
|
| LAMP |
The light switch turns the lamps on and off. |
|
|
|
The blower switch turn the blower on to three speed settings:
0 | - OFF |
|
|
|
1 | - LOW SPEED |
|
|
|
2 | - MEDIUM SPEED |
|
| |
| FIG. 1 |
| ||
3 | - HIGH SPEED |
|
|
|
The pilot lamp lights up whenever the blower is on.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.
1)If blower is OFF - it turns blower ON to HIGH speed.
2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed. When the temperature level drops to normal, the blower will return to its original setting.
WARNING: The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.
HALOGEN BULBS
This range hood requires (4) halogen bulbs (Type T3, 12Volt, 20 Watt Max,
WARNING: Always switch off the electricity supply before carrying out any operations on the appliance.
To change bulbs:
1.Loosen the ring nut by turning it counterclockwise.
2.Remove the bulb by pulling sideward(DO
NOT ROTATE).
CAUTION: Bulb may be hot!
3.Replace with Type T3, 12Volt, 20 Watt Max,
Do not use bulbs greater then 20 Watts. Bulbs greater than 20 Watts will cause fuse to open.
- 4 -
RING NUT
FIG. 2
