Broan E66136SS, E66142SS, E66130WH Use And Care, Wiring Diagram, Avoid when choosing a detergent

10. USE AND CARE

Grease filters and bottom panel.

The grease filters and the bottom panel should be cleaned frequently. Use a warm detergent solution.

Remove grease filters by pushing them towards the back of hood and rotating downward.

Clean all-metal filters in the diswasher using a non-phophate detergent. Discoloration of the filter may occur if using phosphate detergents, or as a result of local water conditions — but this will not affect filter performance. This discoloration is not covered by the warranty.

STAINLESS STEEL CLEANING: HOW TO MAINTAIN ITS “BRIGHT LOOK”

Do: - Regularly wash surfaces with clean cloth or rag soaked with warm water and mild soap or liquid dish detergent.

-Always clean in the direction of original polish lines.

-Always rinse well with clear water (2 or 3 times) after cleaning. Wipe completely dry.

-You may also use a specialized household stainless steel cleaner.

Don’t: -Use any steel or stainless steel wool or any other scrapers to remove stubborn dirt.

-Use any harsh or abrasive cleansers.

-Allow dirt to accumulate.

-Let plaster dust or any construction residues reach the hood. During construction or renovation, cover the hood to make sure no dust adheres to stainless steel surface.

Avoid: when choosing a detergent

-Any cleaners that contain bleach will attack stainless steel.

-Any products containing : chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.

-Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should never be used close to a range.

ENAMEL FINISH:

Clean with warm water and mild detergent only. If discoloration occurs, use a good enamel polish such as automotive polish. (DO NOT use rough abrasive cleaner or porcelain cleaner).

11. WIRING DIAGRAM

!WARNING

Risk of electrical shock. Electrical wiring must be done by qualified personnel in accordance with all applicable codes and standards. Before connecting wires, switch power off at service panel and lock service disconnecting means to prevent power from being switched on accidentally.

Line 120 V
Supply	BK	BK
Neutral	W	W
		Light Socket	W
Ground		W 50 W max.
		Y
		W	Y
		W Light Socket
		50 W max.
		BN	BK
		BL
			BK
FAN MOTOR		G	nc	BK	nc Y [120]
					R [70]
					P [50]
			W	W	BL [35]
					O [0]	nc

	WIRING COLOR CODE
BK	BLACK	P	PURPLE
BL	BLUE	R	RED
BN	BROWN	W	WHITE
G	GREEN	Y	YELLOW
O	ORANGE	nc	no connection

HE0042A

	J5
BK	3	nc
	2
W	1
	J6
Y	3
	2
BK
nc	1
	J4
BK 4
R 3
P	2
BL 1
			ELECTRONIC
	A1		ASSEMBLY
			Main power board	J2
				16
			ELECTRONIC
	A2		ASSEMBLY
			User Interface
			-t°	Heat Sentry

NOTES

1.If any of the original wire, as supplied, must be replaced, use the same equivalent wire.

2.Field wiring must comply with applicable codes, ordinances and regulations.

- 11 -