Broan E662 installation instructions Prepare the Hood, Install the Hood

5. PREPARE THE HOOD

5.1Remove filters from the hood. Remove (3) screws holding both side panels to the hood and set aside. Remove both side panels.

	SCREW LOCATION
1	2	3

HO0042

5.2Punch out 2 knock-out holes for electrical connections (2 on top or one on top and one on back of the hood).

5.3Attach one wire clamp on top of the hood for the provided electrical cable with 3-prong plug. Through the wire clamp, insert this electrical cable in the hood and tighten the wire clamp to secure the cable.

5.4Connect cable wires as follow: BLUE wire with red connector to BLUE wire with red connector (A), BROWN wire with red connector to BLACK wire with red connector (B), GREEN wire under ground screw (C).

DO NOT FORGET TO CONNECT THE GROUND.

6. INSTALL THE HOOD

B

A

C

HE0052

6.1Run power cable to installation location. Position the hood in its intended location. Using a pen mark the position of the screws (smaller part of the keyholes, see pictures below for the (5) keyholes locations). Remove the hood.

6.2Install (4) no. 8 x 1/2” screws, leaving a 1/8” gap (do not install the no. 5 screw yet).

1

2

HD0127

5	3
1
2	4

HD0129

3

4

HD0128

- 7 -