2.3 OPERATING 40425 CONTROLLER
The included wall control 40425 is intented for GSHH3K and GSEH3K units only.
The wall control is in OFF mode when power is applied for the first time. The mode
does not change following a power failure.
2. CONTROLS (CONT’D)
- 6 -
VC0098
ILLUMINATESIN
ALL MODES
EXCEPT OFF
MODE.
•PRESSEITHER
BUTTON TO CHANGE
CONFIGURATIONSETTING
(SEE SECTION 2.3.3).
•P
RESS BOTH
BUTTONS TO RESET
THE FILTERCOUNTER OR
PREFILTER COUNTER.
PRESS THIS BUTTON TO
SWITCH MODE
(SEE SECTION 2.3.2).
FILTER AND PREFILTER
MAINTENANCE LED.
FLASHES WHEN IT IS
TIME TO REPLACE
PREFILTER AND WASH
CORE FILTERS.
SEE SEMI-ANNUAL
MAINTENANCE IN
SECTION 3.1.
LIGHTS UP WHEN IT IS
TIME TO REPLACE FILTER
AND PREFILTER AND
WASH CORE FILTERS.
SEE ANNUAL
MAINTENANCE
SECTION 3.2.
PRESS THIS BUTTON TO
ACCESS CONFIGURATION
PARAMETERS
(SEE SECTION 2.3.3).
40425
2.3.2 USING 40425 CONTROLLER
The wall controller 40425 provides 5 operation modes. Press the Modebutton to
select the desired mode.
The unit exchanges air
at normal speed.
The outdoor
temperature* is displayed.
The unit exchanges air
at high speed.
The outdoor
temperature* is displayed.
NORMAL MODE (MIN)BOOST MODE (MAX)
2.3.1 40425 CONTROLLER DESCRIPTION
* The outdoor temperature reading is taken from the unit

FRESH AIR FROM

OUTSIDE

port; due to the lenght of the insulated duct, the reading is slightly
different from the real outside temperature.