Broan QS1 Non-DuctedInstallation - Skip to “Connect, Wiring” section, The following, Steps 6 thru

PREPARE THE HOOD

3	Remove
	Damper/Duct
	Connector from
	inside the hood.
	Set connector
	aside - with
	mounting screws
	and parts bag.

DAMPER/DUCT

CONNECTOR

4	Remove
	Wiring Cover
	from inside the
	hood. Set
	cover and
	mounting
	screw aside.

WIRING

COVER

5	Remove either
	top or back
	wiring knockout
	and install
	approved

Electrical Cable

Clamp.

ALLURE™ QS1 SERIES

RANGE HOOD

Page 3

PREPARE THE HOOD

AIR CHUTE

7	Remove Air
	Chute - held in
	place with one
	(1) screw.

NOTE: Be careful not to disconnect any wires.

8	Remove Baffle
	from air chute.

»	BAFFLE
BAFFLE
	»

ELECTRICAL CABLE CLAMP

Non-Ducted Installation - Skip to “Connect
Wiring” section.	(3) #8 SCREWS	LIGHT
The following		PANEL
Steps (6 thru	(2) #8 SCREWS
13) are for
DUCTED
INSTALLATION
ONLY.

6 Remove Light Panel - held in place with (3) #8 screws and (2) #8 screws. Disconnect light assembly wire harness

(white connector).

9

10

	»
Rotate baffle.
Reinsert baffle into
air chute (as	SLOTS
shown) so that
baffle tabs fit all the
way into slots in air
chute. An audible
“click” will be heard
when fully installed.
This will close off
the air flow through
the non-ducted	»
slots on top of
hood.

Re-install air chute, re-connect wire harness, and replace light panel.

NOTE: Be careful not to trap wires between support fin and light panel.

TABS

»

SUPPORT FIN