Broan QS1 warranty Connect Wiring, from being switched on accidentally, Prepare The Hood, Page

ALLURE™ QS1 SERIES RANGE HOOD

Page 4

PREPARE THE HOOD

TOP RECTANGULAR
DUCT KNOCKOUT	SEMI-CIRCULAR
(Remove for 3¼” x 10”
	DUCT KNOCKOUT
Vertical & for 7” Round
	(Remove for 7” Round
Discharge)
	Discharge)

REAR

RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10” Horizontal Discharge)

11Remove appropriate Duct Knockout(s) from top or back of hood.

CONNECT WIRING

WARNING: To reduce the risk of electric shock, make sure power is switched off at the service panel. Lock or tag service panel to prevent power

from being switched on accidentally.

HOUSE WIRING (120 VAC)

CARDBOARD (Use to protect cooktop)

UP TO 1”	TAPE
SIDE-TO-SIDE
ADJUSTMENT

1

TOP/BACK

EDGE

Connect House Wiring (120 VAC) to hood. Use a piece of Cardboard to protect the cooktop, if necessary.

	➙
	➙
PIVOT	DAMPER/DUCT
	CONNECTOR
	(Vertical discharge
	position shown)

12 3¼” x 10” Ducted Discharge Only: Attach Damper/Duct Connector over knockout opening. Make sure damper Pivot is nearest to Top/Back Edge of hood. Remove Tape from damper flap.

137” Round Ducted Discharge Only: Re-install 7” Round Duct Plate removed in Step #1 under “PREPARE THE HOOD” section. Install a 7” round damper (purchase separately). Damper flap must open freely in direction of air flow (away

from range hood).

GREEN

GROUND

SCREW

2 Connect house black to hood black wire, house white to hood
	white wire, and house ground under Green Ground Screw.
	Securely tighten cable clamp onto house wiring.
3	Replace wiring cover.

NOTE	To accomodate off-center ductwork, the Damper/Duct
	Connector can be installed up to 1-inch on either side of

hood center or the 7” Round Duct Plate can be installed up to ½” on either side of hood center. In extreme off-center installations, one end of the duct connector may need to be trimmed to clear the electrical cable clamp.