Broan Install Hood, Operation, Cleaning, Non-Ductedfilters, ALLURE QS1 SERIES, Range Hood

	ALLURE™ QS1 SERIES
	RANGE HOOD
	Page 5
INSTALL HOOD	NON-DUCTED FILTERS

	KEYHOLE
	(4)
	MOUNTING
	SCREW
	(4)
1 Hang hood from (4) Mounting Screws (from parts bag). Slide
hood towards wall until mounting screws are engaged in
narrow end of (4) Keyholes. Tighten mounting screws
securely.
CAUTION	DO NOT PUSH ON FAN BLADE. Pushing on the
	blade may cause it to interfere with other hood parts.
	DUCT
	TAPE

2 Connect ductwork to hood. Use Duct Tape to make joints secure and air tight.

PAR20,

50W MAX.

HALOGEN

BULB (2)

- or - R16, 40W MAX.

INCANDESCENT

BULB (2)

3 Install (2) PAR20, 50 W Maximum Halogen Bulbs or (2) R16, 40 W Maximum Incandescent Bulbs. Purchase bulbs

separately.

!CAUTION: Bulbs may be hot! Refer to bulb packag- ing for further information.

4 Replace filters and make sure fan blade turns freely. Turn on power at service panel, and test for proper operation.

If hood is to be installed Non-Ducted:

Purchase a set of (2) non-ducted filters from your local distributor or retailer and attach them to the aluminum mesh filters.

OPERATION

Fan: The 3-position rocker switch (on the left) controls the fan. The left position is low speed, center position is off, and right posi- tion is high speed. An indicator light shows that the fan is on.

Light: The 3-position rocker switch (on the right) controls the lights. The left position is low light intensity, center position is off, and right position is high light intensity.

CLEANING

WARNING: To reduce the risk of electric shock, disconnect from power supply before cleaning.

Aluminum mesh filters: Clean frequently using hot water and a mild detergent. Filters are dishwasher safe.

Charcoal filters: Clean filter surfaces frequently with a damp cloth and a mild detergent. DO NOT immerse filters in water or put in dishwasher. The special “Clean Sense” feature indicates when the filter is to be replaced. The blue and yellow strips will blend to green when it is time to change the filter. The “Clean Sense” fea- ture works best when facing toward the cooking surface.

To clean hood: Remove filters. Use a damp cloth and a mild de- tergent to wipe all grease-laden surfaces. Use care when cleaning fan blade - it must not become bent or misaligned. DO NOT AL- LOW WATER TO ENTER MOTOR. Make sure all surfaces are completely dry before re-installing filters and restoring power.

Motor is permanently lubricated. Do not oil or disassemble motor.