Broan QS342SS warranty Prepare Hood Location, Prepare the Hood, ¼ X, Round Duct Plate, Filters

ALLURE® QS3 SERIES RANGE HOOD

PREPARE HOOD LOCATION

ROOF CAP	3¼" X 10" or
	7" ROUND DUCT
	(For vertical
	discharge)

SOFFIT
	HOUSE WIRING
CABINET	(Top or Back of hood)
	WALL CAP
HOOD
24" - 30" ABOVE	3¼" X 10" DUCT
COOKING SURFACE
	(For horizontal discharge)
1 Determine whether hood will discharge vertically (3¼” x 10”
or 7” Round), or horizontally (3¼” x 10” only). For vertical or
horizontal discharge, run ductwork between the hood location
and a roof cap or wall cap. For best results, use a minimum
number of transitons and elbows.
2 Use diagrams, below, for proper placement of ductwork and
electrical cutout in cabinet or wall. For a non-ducted installa-
tion, DO NOT cut a duct access hole.

HOOD MOUNTING SCREWS (4)			3¼” X 10”
			VERTICAL DUCTING
1315/16" (30" hood)
		1315/16" (30" hood)
1615/16" (36" hood)
1915/16" (42" hood)		1615/16" (36" hood)
CABINET FRONT		1915/16" (42" hood)
		7½"
	CABINET BOTTOM
	5¼"	5¼"	2"	10½"
	VERTICAL DUCT
5"	ACCESS HOLE
	1¼"			1½"

		ELECTRICAL
WOOD SHIMS		ACCESS HOLE
	CENTER
(recessed-bottom		(in cabinet bottom)
	LINE
cabinets only)
WOOD SHIMS		3¼” X 10”
(recessed-bottom		HORIZONTAL DUCTING
cabinets only)
	CABINET FRONT
		1/8" ¾"

3¾"	HORIZONTAL DUCT
	ACCESS HOLE
CABINET
	5¼"	5¼"
BOTTOM
1315/16" (30" hood)		7½"
		1315/16" (30" hood)
1615/16" (36" hood)
		1615/16" (36" hood)
1915/16" (42" hood)
		1915/16" (42" hood)
HOOD
			ELECTRICAL
MOUNTING	CENTER
			ACCESS HOLE
SCREWS (4)	LINE
			(in wall)

Page 2

PREPARE HOOD LOCATION

7” ROUND

VERTICAL DUCTING

3 Run house wiring between service panel and hood location.

PREPARE THE HOOD

7” ROUND

DUCT PLATE

1Remove 7” Round Duct Plate from top of hood. Set duct plate aside - with mounting screws.

FILTERS

2 Remove tape holding Filters in place. Pull down on filter tabs or finger holes and lift filters out. Set filters aside.