Broan RM51000, RM52000 manual Non-ducted recirculation Configuration

Non-ducted recirculation Configuration

1.Adjust the width of the flue mounting bracket to equal the inside width of decorative flue. Insert and tighten mounting screws to hold bracket width.

2.Use mounting screws and wall anchors to secure flue mounting bracket to the ceiling as shown.

3.Turn upper flue section upside down so air vents are at the top. Slide upper flue section into lower flue section.

4.Connect the non-ducted recirculation plenum to the upper flue section with (4) flat-head screws (supplied).

5.Install the reduction on the discharge collar.

6.Measure the distance from the top of the reduction to the ceiling. Cut a length of 5" round metal duct 5" shorter than this dimension.

7.Fit duct section over the non-ducted recirculation plenum. For best fit, make sure duct seam is toward the front.

8.Set duct/flue assembly on hood with top tilted away from wall. Reach around flue to engage bottom of duct with discharge collar on hood. Tilt flue up against wall. Duct seam can be cut to length if necessary.

9.Extend the upper flue to the ceiling and secure with two mounting screws.

	AIR	UPPER
UPPER	VENTS	BRACKET
	(in upper flue section)
FLUE SECTION
NON-DUCTED		!
RECIRCULATION
PLENUM
LOWER
FLUE SECTION
5" ROUND	DUCT	MEASURE
	SEAM
METAL DUCT
REDUCTION		!
DISCHARGE
COLLAR

FLUE MOUNTING

BRACKET

MOUNTING SCREWS

MOUNTING SCREWS

=

=

FASTEN FLUE TO

UPPER BRACKET

WITH MOUNTING

SCREWS

- 8 -