6. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are specially designed to protect the exterior base of the custom hood. To order, refer to the table below to find the right liner model number for your insert and width of custom hood. To view specific model information, including depths for each liner models, visit www.broan.com or contact Technical Support (phone number listed on front cover). To install, see instruction packed with custom hood liner.
The liner must be installed before the insert.
NOTE: On some liners models, front liner piece may overlap front insert flange. If so, remove the front liner piece, assemble insert, and reassemble front liner piece.
| LINER MODEL | INSERT MODEL | CUSTOM HOOD | |
|
|
| NOMINAL WIDTH |
|
| RML3336S | RMIP33 | 36’’ |
|
| RML3342S | RMIP33 | 42’’ |
|
| RML4548S | RMIP45 | 48’’ |
|
| RML4554S | RMIP45 | 54’’ |
|
| RML4560S | RMIP45 | 60’’ | |
|
|
|
|
|
HA0038A |
7. INSTALL THE RMIPWC REMOTE CONTROL (OPTIONAL)
The electrical connection for the remote control is located in front of the insert. Perform this connection before the insert installation. For installation details, see installation instructions included with the RMIPWC remote control.
HL0044 |
8. CUT THE HOLE IN CUSTOM HOOD BASE
If it is not done yet, cut a hole in the bottom of the cabinet, using the dimensions shown beside.
INSERT MODEL NUMBER | A | ||
| RMIP33 | 321/2’’ |
|
| RMIP45 | 441/2’’ | |
NOTES: 1. The notch shown in the inset must be cut only if the RMIPWC optional remote control will be installed.
2.The recommended distance from the back to the rearmost cutout edge is 21/4’’ minimum.
| 3 1/2'' | |
17 1/16'' | 16 3/8'' | |
2 1/4'' | A | |
min. | ||
| ||
HD0084 |
|
9. INSTALL BLOWER (INTERIOR OR EXTERIOR BLOWER)
INTERIOR BLOWER: | Follow all subsequent steps of this manual. |
EXTERIOR BLOWER: | Refer to instructions packed with exterior blower and follow steps 13, 14, 16, 17, 19 and |
| up of this manual. |
- 7 -
