Broan WPD29M installation instructions Remove the Transition, Install Wood Mounting Strip

5. REMOVE THE TRANSITION

Using a Phillips no. 2 screwdriver, remove and discard both screws and washers retaining the transition to the hood. Remove the transition and the wood mounting strip (on back of hood) and set aside.

RETAINING SCREWS AND

WASHERS LOCATION

HD0191

6. INSTALL WOOD MOUNTING STRIP

Measure and mark a level line on wall above cooktop location for the wood mounting strip (see illustration on page 4).

Center the wood mounting strip over location. See illustration shown at side. Use #10, 2’’ flat head screws to secure the mounting strip to the drywall. Make sure to hit the wall studs.

CAUTION

Due to the weight of this hood, ensure that the wood strip is attached to every available stud, not into the drywall alone.

HD0192A

1.	Drywall	4. Wall anchor location
2. Wood mounting strip		5. Back of hood outline
3.	Flat head screw	6. Wall studs

7.SELECT BLOWER OPTION (EXTERIOR OR INTERIOR)

INTERIOR BLOWER: Follow all subsequent steps of this manual.

EXTERIOR BLOWER: Discard the exterior blower rough-in plate. Refer to instructions packed with exterior blower and follow steps 8 to 11, 13 and up of the present manual.

- 6 -