BDA Single Door Installation
Attention: If Applicable, remove protective film from parts before installation.
Recommended Tools: Phillips Screw Driver or an electric screw driver.
1
The BDA Single Door will be fully assembled when it is shipped out. Remove door from frame by depressing one of the spring loaded pins and set aside.
FIGURE 1.
SCREW (8)
FIGURE 3
FIGURE 1
2
Make sure BDA Single Door opening dimensions match those in FIGURE 2. Place the Frame into the opening and check for proper hole alignment. Secure the Frame to the grill enclosure with eight (8) 8 x 3/4” Hex Head Screw screws. FIGURE 3.
3
Secure the BDA Door to the door frame by inserting the spring loaded pin in the bottom frame hole. Locate the upper hole in the frame then push on the spring loaded pin on the door and insert the door in the frame.
Figure 4.
Make sure the Door is Aligned and Secured prop- erly by opening and closing door
14”
19 13/16”
FIGURE 2 | FIGURE 4 |
Page 20 |
