6.The burner bracket should be at a slight angle as shown in Figure 12. Once the proper angle is achieved, tighten the screw securing the burner bracket to the venturi assembly and burner body.
Installing the Burner
1.Insert the burner assembly into the grill bottom with the venturi tubes facing the front of the grill. See Figure 14.
11°
C
L
“H” Series Burner Shown
Figure 12
7.Insert the
Figure 13.
Figure 13
Figure 14
Note: If the Grill Head is installed on a PCB1 or DCB1, make sure the cart shield is not installed until the burner bracket is mounted.
2.Slide the venturi on to the valve assembly.
3.Raise the unsecured end of the burner bracket and slip it over the
15. The screw will fit into the hole on the burner bracket.
“P” Series Shown
Figure 15
Page 27 |