Brother 1950 Tab, CHRS, LINE, FULL, TAPE, Cause, ERROR, ERROR, INVAL, LIMIT, LIMIT, FILES, Remedy, EEPROM, LENGTH, MEMORY, INTERFACE

Error Message	Cause	Remedy
EEPROM	This message appears if a checksum	Contact your service representa-
ERROR!	error occurred when the P-touch was	tive.
	turned on or if the keyword was dam-
	aged and it failed to initialize.
INTERFACE	This message appears if an error	Cancel the print job, and then
ERROR!	occurs while data is being sent from	try printing again.
	the computer to the P-touch.
INVAL.	This message appears if the cursor is	Move the cursor below a num-
CHRS!	not below a number when you hold	ber before holding down
	down c and press O.	c and pressing O.
LENGTH	• This message appears if the text is	• Shorten the text to less than 3’
LIMIT!	longer than 3’ 3 1/3” (1 meter) when	3 1/3” (1 meter) before trying
	you try to print.	to print.
	• This message appears if the Length	• Set the label length between
	function is used to set a label	1.6” (4.0 cm) and 11.8” (30.0
	length that is less than 1.6” (4.0	cm).
	cm) or more than 11.8” (30.0 cm).
	• This message appears if the Tab	• Set the tab length so that it is
	Length function is used to set a tab	less than 11.8” (30.0 cm).
	length that is more than 11.8”
	(30.0 cm).
LINE	This message appears if the number	Reduce the number of lines or
LIMIT!	of lines in the text is greater than the	install a tape of greater width.
	maximum number of lines possible
	for the installed tape.
MEMORY	This message appears if you try to	Delete an unwanted file to make
FULL!	store a text file after the maximum	room for the new one.
	number of characters has already
	been stored in the memory.
NO	This message appears if you try to	Store a text file first.
FILES!	recall or delete a text file from the
	memory when none are stored.
NO	This message appears if you try to print	Install a tape cassette and try
TAPE!	a label or feed the tape when no tape	again.
	cassette is installed.

49