Chapter 11
11 - 3
Machine too Hot The inside of the machine is too hot. Make sure you can hear the fan in the machine
spinning and the exhaust outlet isn’t blocked by
something.
If the fan is spinning , remove any obst acles that
surround the exhuast outlet, an d then leave the
machine turned on but do not use it for several
minutes.
If the fan is not spinning, you ne ed to save the faxes
before you follow the suggestions below.
(For FAX-2820 and MFC-7220)
When you turn off the machin e's power switch its
memory will be clear ed. To check wheth er the
machine has faxes in its memo ry see Checking if the
machine has faxes in its memory on page 11-6. If there
are faxes you need to save them before following the
suggestions below (T o save the faxes, see Forwarding
faxes to another fax machine on page 11-6. For
MFC-7220 also see Trans ferring faxes to your PC
(MFC-7220 and MFC-7225N only) on page 11-6).
Turn off the machine's power swi tch and then turn it on
again. If the error message continues, leave the
machine for several minutes and try it again.
(For FAX-2920 and MFC-7225N)
Turn off the machine's power swi tch and then turn it on
again. If the error message continues leave the
machine for several minutes and then try it again. (The
machine can be turned off for up to 4 days without
losing faxes stored in the memory.)
No cartridge The ton er cartridge is no t installed
properly.
Reinstall the toner cartridge.
No Paper Fed The machine is out of paper or paper is
not properly loaded in the paper tray.
Refill the paper in the paper tray and then press Start.
OR
Remove the paper and load it again and then press
Start.
No Response/Busy The number you dialed do es not
answer or is busy.
Verify the number and t ry again.
Not Registered You tried to access a One-Touch or
Speed Dial number that is not
programmed.
Set up the One-Touch o r Speed Dial numb er.
(See Storing One-Touch numbers on page 5-1 and
Storing Speed-Dial numbers on page 5-2.)
ERROR MESSAGES
ERROR MESSAGE CAUSE AC TION