Brother Sewing buttons, Turn on the machine, 5Turn on the machine, 2Turn off the machine, and then tie it with the bobbin thread

SEWING BUTTONHOLES AND BUTTONS ————

1

2

4Placeplate. the darning plate on the needle

3 3

1Buttonhole fine-adjustment screw

2 Left side

3 Buttonhole appearance

If the left side is too open, turn the buttonhole fine-adjustment screw with a large screwdriver in the “–”direction.

If the left side is too tight, turn the buttonhole fine-adjustment screw with a large screwdriver in the “+” direction.

•This adjustment ensures both sides of the buttonhole are the same.

Sewing buttons

		Stitch	Stitch
Stitch	Pattern	Length	Width	Foot	Other
Name		[mm	[mm
		(inch)]	(inch)]
	3			Button
Zigzag		F	Any	Sewing	Darning
Stitch		(1/64)		Foot	Plate
				“M”

1Measure the distance between the buttonholes and mark the fabric. Then adjust the stitch width so that it is the same as the distance between the holes in the button.

2Turn off the machine.

3Change“M”. the foot to the button sewing foot

5Turn on the machine.

6Put a button between the foot and the fabric and make sure that the needle enters the holes without hitting the button. If it hits, see step 1.

7At a slow speed, sew about 10 stitches.

CAUTION

●Make sure the needle does not hit the button during sewing. The needle may break and you may be injured.

8Pull the upper thread at the end of the stitching to the wrong side of the fabric,

and then tie it with the bobbin thread.

X Use scissors to cut the upper thread and the bobbin thread at the beginning of the stitching.

37