Brother CS-8150 manual Needle and presser foot section Right-side/rear view, Getting Ready

——————————————————————————————————————— Names of Machine Parts and Their Functions

Needle and presser foot section

1

Right-side/rear view

1

CONTENTS

7
6	5

2

3

4

2

3

7

46

5

GETTING READY

1Buttonhole lever

Lower the buttonhole lever when sewing buttonholes and bar tacks.

2Needle bar thread hook

Pass the upper thread through the needle bar thread hook.

3Needle plate

The needle plate is marked with guides for sewing straight seams.

4Bobbin cover/shuttle

Remove the bobbin cover, and then insert the bobbin into the shuttle.

5Feed dogs

The feed dogs feed the fabric in the sewing direction.

6Presser foot

The presser foot applies pressure consistently on the fabric as the sewing takes place. Attach the appropriate presser foot for the selected stitching.

7Presser foot holder

The presser foot is installed onto the presser foot holder.

1Handle

Carry the sewing machine by its handle when transporting the machine.

2Balance wheel

Turn the balance wheel toward you to raise and lower the needle to sew one stitch.

3Main power switch

Use the main power switch to turn the sewing machine on and off.

4Power supply jack

Insert the plug on the power supply cord into the power supply jack.

5Foot controller jack

Insert the plug on the end of the foot controller cable into the foot controller jack.

6Air vent

The air vent allows the air surrounding the motor to be exchanged. Do not cover the air vent while the sewing machine is being used.

7Feed dog position switch

Use the feed dog position switch to lower the feed dogs.

Memo

●Refer to Cover B, D or E pages while you are learning to use your machine.

SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

Cover C