Brother CS-8150 manual Winding/Installing the Bobbin, Bobbin precautions, Winding the bobbin

GETTING READY ———————————————————————————————————————————————————

Winding/Installing the Bobbin

This section describes how to wind the thread onto the bobbin, and then insert the bobbin thread.

Bobbin precautions

Be sure to observe the following precautions concerning the bobbin.

CONTENTS

CAUTION

●Only use the bobbin (part code: SA156, XA5539-151) designed specifically for this sewing machine. Use of any other bobbin may result in injuries or damage to the machine.

●The enclosed bobbin was designed specifically for this sewing machine. If bobbins from older models are used, the machine will not operate correctly. Use only the enclosed bobbin or bobbins of the same type (part code: SA156, XA5539-151).

Actual size

11.5mm (7/16 inch)

This model Older model

Winding the bobbin

Wind the thread around the bobbin to prepare the bobbin thread.

GETTING READY SEWING BASICS

1Turn on the sewing machine.

2Open the bobbin winder cover at the top on the right side of the sewing machine.

3Swing up the bobbin thread spool pin.

Move the bobbin thread spool pin up as far as possible.

1

1Bobbin thread spool pin

4Place the bobbin on the bobbin winder shaft so that the spring on the shaft fits into the notch in the bobbin.

UTILITY STITCHES APPENDIX

1

2

INDEX

1Notch

2Bobbin winder shaft spring

18