Brother CS-8150 manual Changing the stitch width Adjust the stitch width

8Raise the presser foot lever, remove the fabric, and then cut the thread.

9Raiseposition.the buttonhole lever to its original

0Insert a pin along the inside of one bar tack at the end of the buttonhole stitching to prevent the stitching from being cut.

1

1Pin

aUse the seam ripper to cut towards the pin and open the buttonhole.

1

1Seam ripper

For keyhole buttonholes, use the eyelet punch to make a hole in the rounded end of the buttonhole, and then use the seam ripper to cut open the buttonhole.

1

1Eyelet punch

•When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric.

CAUTION

●When opening the buttonhole with the seam ripper, do not place your hands in the cutting direction, otherwise injuries may result if the seam ripper slips.

■Changing the density of the stitching Adjust the stitch length.

–+

•For details, refer to “Adjusting the stitch length” (page 58).

•If the fabric does not feed (for example, if it is too thick), decrease the density of the stitching.

■Changing the stitch width Adjust the stitch width.

–+

•For details, refer to “Adjusting the stitch width” (page 57).

Memo

●Before sewing buttonholes, check the stitch length and width by sewing a trial buttonhole on a scrap piece of fabric.

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

Buttonhole Stitching 79