Brother HL-5270DN Error message printout

7. Troubleshooting
94
Error message printout
The printer can also report problems by printing an error message. Use the table below to identify and clear
the error message. The default setting for the the error message printout is off. If you want to turn the error
message printout on, from the Advanced tab of the Windows printer driver click the Device Options icon,
and then choose Error Message Printout.
Error message Action
MEMORY FULL Press Go to print the remaining data in the printer memory. Cancel the print job
if you want to delete the remaining data in the printer memory. See Buttons on
page 48.
Reduce the complexity of your document or cut the print resolution.
Add more memory. See Installing extra memory on page 71.
PRINT OVERRUN Press Go to print the remaining data in the printer memory. Cancel the print job
if you want to delete the remaining data in the printer memory. See Buttons on
page 48.
If this does not clear the error, reduce the complexity of your document or cut the
print resolution.
Add more memory. See Installing extra memory on page 71.
Set page protection to AUTO by using the supplied Windows® driver or the
control panel.
Change the following settings in the supplied Windows® driver and try again. The
best combination of these settings will vary depending on your document:
• Graphics mode
• TrueType mode
• Use Printer TrueType® Fonts
RESOLUTION REDUCED TO
ENABLE PRINTING
(The printer has printed the
document at a reduced
resolution)
Reduce the complexity of your document before you print to prevent automatic
reduction in the resolution.