Troubleshooting Tips
ProblemSolution
The cutter does not cut cleanly or must be run across the backing material several times.
The item does not feed properly.
When using the laminate cartridge, air bubbles appear.
Clean the cutter and area (see below). Or replace the cutter.
Be sure that the cartridge is properly installed.
Be sure the top cover is closed.
Do not hold on to the item as you turn the knob; allow it to feed freely through the
Turn the knob to feed laminate film until there are no visible bubbles. Or replace the cartridge.
Maintaining the LX-570
To maintain your
To clean the cutter area:
Moisten the end of a cotton swab in isopropyl (rubbing) alcohol. Use the moistened end to remove dust, adhesive, or debris from the cutter blade, groove, and exit area.
Always be careful to avoid touching the blade.
Groove
To clean the rollers:
Open the top cover and remove the cartridge. Moisten a soft cloth or cotton swab with isopropyl (rubbing) alcohol to remove dust, adhesive, or debris from the rollers.
There are two rollers.
