Brother warranty About the LX-570, How to Use the LX-570, Cutter bar, Knob

User’s Guide

LX-570

The LX-570 applies an adhesive, laminate, or magnetic backing to an item without using heat or electricity. You choose a backing by swapping the drop-in cartridge.

About the LX-570

Top Cover. Your LX-570 comes with a "starter" cartridge already installed, which applies a permanent adhesive backing to an item.

Cutter. The cutter is for trimming the backing material and slides on the cutter bar. It can be replaced.

Cutter bar Exit area

Knob

The LX-570 comes with a starter cartridge already installed. This cartridge applies a permanent adhesive backing and is shorter than replacement cartridges.

See the reverse for available cartridges and for application ideas on using your LX-570. First, take a few minutes to read these instructions.

Feed Deck. The LX-570 is designed for use with items up to five inches wide. It works best with item thicknesses between 20 pound bond paper and 100 pound card stock or construction paper (min. thickness is 0.004 inches, max. thickness is 0.010 inches).

Latch (opens top cover)

Notes:

Before using, remove the protective tape and other packaging materials under the top cover.

Under the terms of an agreement with Xyron, Inc., the purchase or

other acquisition of this product confers no right or license to use

the product in the Retroreflective Field.

How to Use the LX-570

1Insert the item face up at the feed deck and turn the knob in the direction

of the arrows only; do not turn knob backwards.Insert the item:

Insert the item and be sure it is straight.

Insert until you feel contact; then release it as you turn knob.

Feed straight, not at an angle.

Turn the knob forward only.

Cut:

2 When the item clears the cutter at the exit area, gently push down on the cutter knob and slide it all the way to the left or right.

To avoid wasting the backing material, note the location of the cut. Feed only enough material to clear the cutter.

When Using the

Starter Cartridge...

Feed and cut the item as described here. Be sure to feed face up.

Press down firmly around all the edges. This action prevents adhesive from remaining on the front of the item. Then remove the clear film and discard carefully as it is sticky.

When you are ready to place the item on a surface, peel it from the white backing.

This starter cartridge contains five feet of backing material. After you use it a few times, always make certain that it contains sufficient material. If uncertain, install a new cartridge to avoid partial processing.

Note: the starter cartridge is shorter than the replacement cartridges. See the other side for cartridge descriptions and lengths. Always consult packaging of replacement cartridges.