Brother LX2500 Attaching the extra spool pin, Twin needle threading, Thread the left needle

SEWING BASICS——————

■Attaching the extra spool pin

Insert the extra spool pin onto the end of the bobbin winder shaft. Install the second thread spool onto the extra spool pin.

	1	Bobbin winder shaft
3	2	Extra spool pin
2	3	Thread spool
1

■Twin needle threading

You should thread each needle separately.

1 Thread the left needle.

Follow the same instructions for threading a single needle (see page 14).

2 Thread the right needle.

Thread the right needle in the same way that you threaded the left needle using the thread from the spool on the extra spool pin, but do not pass the thread through the guide above the needle before you pass it through the eye of the right needle.

3 2

1

1 Left needle thread passes through the needle bar thread guide

2Right needle thread passes in front of the needle bar thread guide

3Needle bar thread guide

3Attach zigzag foot “J”.

For details on changing the presser foot, refer to “Changing the presser foot” on page 8.

CAUTION

●When using the twin needle, be sure to attach zigzag foot “J”, otherwise the needle may break or the machine may be damaged.

4Turn on the machine.

5Select a stitch.

CAUTION

●After selecting a stitch, slowly turn the handwheel toward you (counterclockwise) and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break.

●The twin needle should only be used with the Straight Stitch (Center Needle Position) and the Zigzag Stitch (1.5 mm (1/16 inch) width). Do not use the twin needle with any other stitches.

21