Brother NC-110H Setup Misc.

3 - 10 FRONT PANEL SETUP

NC9100h_FM6.0

Setup Misc.

Ethernet

Ethernet link mode. Auto allows the print server to operate in

100BaseTX full or half duplex, or in 10BaseT full or half duplex mode

by auto negotiation.

100BaseTX Full Duplex (100B-FD) or Half Duplex (100B-HD) and

10BaseT Full Duplex (10B-FD) or Half Duplex (10B-HD) fix the print

server link mode. This change is valid after the print server has been

reset (default is Auto).

Press Menu/Set, 5, 2, 1. (4, 2, 1 for MFC-5440CN)

Press ▲ or ▼ to select Auto/100B-FD/100B-HD/

10B-FD/10B-HD.

Press Menu/Set.

Press Stop/Exit.

If you incorrectly set this value, you may not be able to

communicate with your print server.

Contents

Main i Trademarks Compilation and Publication ii iii IMPORTANT INFORMATION: REGULATIONS Federal Communications Commission (FCC) Declaration of Conformity (For U.S.A. only) Important Industry Canada Compliance Statement (For Canada only) iv Declaration of Conformity (Europe) Caution for LAN connection Intel Copyright and License Information v Table of Contents vi vii Introduction Computer Network Basics Protocols Protocol Configuration Items TCP/IP Configuration Page Network Connection Types of Network Peer-to-Peer Printing Network Example Example : Peer-to-Peer (TCP/IP) TCP/IPTCP/IP Features Network Printing Network Scanning Network PC-FAX Network PhotoCapture Center (not available for MFC- 5440CN) Page TCP/IP Configuration Assigning TCP/IP Information (Basic) Using the machines control panel to allocate an IP address Changing the IP Address using the BRAdmin Professional utility Using BRAdmin Professional utility and the TCP/ IP Protocol to set the IP address Assigning TCP/IP Information Automatically (Advanced) Using DHCP to Configure the IP address Using APIPA to Configure the IP Address Using RARP to Configure the IP Address Using BOOTP to Configure the IP Address Page Front Panel Setup LAN Main Setup Menu Setup TCP/IP Page Page Page Page Page Page Page Setup Misc. Network Configuration List Restoring the Network Settings to Factory Default Network Printing from Windows (Peer to Peer) For Windows 2000/XP, LAN Server and Warp Server users Windows 2000/XP (TCP/IP) Configuration Windows 2000/XP Printing (Printer Driver not yet installed) Windows 2000/XP Printing (Printer Driver already installed) For Windows 98/Me users TCP/IP Printing Installing the Brother Peer to Peer Software Associating to the printer Adding a Second Brother LPR Port Other Sources of Information Network Printing from Macintosh TCP/IP Printing for Macintosh Page Page Troubleshooting Installation problems a b 4 b a Intermittent Problems TCP/IP Troubleshooting Windows 98/Me Peer to Peer Print (LPR) Troubleshooting Brother Internet Fax Printing Software (FAX-1940C/MFC-3340CN/ MFC-5440CN/MFC-5840CN only) Installing Brother Internet Fax Printing Driver Page Changing the BFP Port Settings Relay Broadcast Function Page Uninstalling from Windows 98/Me/2000/XP Page Using the BFP Address Book Page Setting Up a Group for Broadcasting Page Sending a Network Fax with BFP A Appendix Appendix A General Information BRAdmin Professional utility (Recommended) Using Services General Appendix B Updating other machines through the Network (Windows only) Page Page Appendix C Specifications Operating System Support Protocol Support Network Network Scanning Management Utilities A - 9 APPENDIX Function Table and Factory Default Settings INDEX