5Netware GET from a server

You must have a Netware server on your network (running IPX/ SPX) and you must store the new firmware file in the SYS/Login directory of the server. In this case, your PC makes the Print/Fax server read the firmware data from the assigned Netware server, the Print/Fax server attaches to the Netware server and reads the firmware itself.

After sending firmware to the machine, do not turn off the machine until after the machine has performed an automatic restart.

Reloading using the FTP Protocol from a command prompt

By specifying the Print/Fax server PASSWORD AS THE USERNAME when logging on, it becomes possible to upgrade the firmware of the Print/Fax server or printer (if supported). The following example assumes that the Print/Fax server password is

cambridge

D:\>ftp

ftp> open 220.0.250.200 Connected to 220.0.250.200.

220FTP print service:V-1.05/Use the network password for the ID if updating.

User (220.0.250.200:(none)): cambridge

230User cambridge logged in. ftp> bin

200Ready command OK. ftp> hash

Hash mark printing on ftp: (2048 bytes/hash mark) . ftp> send brnt261.blf

200Ready command OK.

150Transfer Start

#################################################

########

#################################################

#################################################

#################################################

###########################

226Data Transfer OK/Entering FirmWareUpdate mode. ftp: 1498053 bytes sent in 8.52Seconds 175.77Kbytes/sec.

ftp> close

226Data Transfer OK.

APPENDIX A - 6