Bryant 223A manual Electrical Data, Or CKT, 018---C

ELECTRICAL DATA

								MIN	MIN	MAX	MAX	MAX
UNIT SIZE---		OPER VOLTS*		COMPR		FAN		WIRE	WIRE	LENGTH	LENGTH	FUSE**
	V/PH						MCA	SIZE†	SIZE†	ft (m)‡	ft (m)‡	or CKT
SERIES
												BRK
		MAX	MIN	LRA	RLA	FLA		60° C	75° C	60° C	75° C
												AMPS
018---C				48.0	9.0	0.7	11.9	14	14	66 (20.1)	62 (18.9)	20
024---B				58.3	12.8	0.7	16.7	14	14	47 (14.3)	45 (13.7)	25
030---C				77.0	16.0	0.8	20.8	12	12	60 (18.3)	57 (17.4)	30
036---C	208/230/1	253	197	79.0	17.1	0.9	22.3	12	12	56 (17.1)	53 (16.2)	35
042---B				109.0	19.9	1.2	26.0	10	10	77 (23.5)	73 (22.3)	40
048---B				117.0	27.3	1.2	35.4	8	8	88 (26.8)	84 (25.6)	50
060---B				134.0	26.3	1.2	34.1	8	8	91 (27.7)	87 (26.5)	50
030---B				71.0	10.0	0.8	13.3	14	14	64 (19.5)	61 (18.6)	20
036---C				73.0	11.5	0.9	15.3	12	12	94 (28.7)	90 (27.4)	25
042---B	208/230/3	253	197	88.0	13.5	1.2	18.0	10	10	128 (39.0)	122 (37.2)	30
048---B				83.1	17.2	1.2	22.7	8	10	158 (48.2)	97 (29.6)	35
060---B				110.0	17.0	1.2	22.5	8	10	160 (48.8)	98 (29.9)	35
036---C				38.0	5.2	0.5	7.0	14	14	260 (79.2)	247 (75.3)	15
042---B	460/3	506	414	46.0	7.1	0.53	9.3	14	14	196 (59.7)	186 (56.7)	15
048---B				41.0	7.5	0.6	10.0	14	14	182 (55.5)	173 (52.7)	15
060---B				52.0	7.8	0.6	10.3	14	14	177 (54.0)	168 (51.2)	15

*Permissible limits of the voltage range at which the unit will operate satisfactorily

{If wire is applied at ambient greater than 30_C, consult table 310---16 of the NEC (ANSI/NFPA 70). The ampacity of non ---metallic---sheathed cable (NM), trade name ROMEX, shall be that of 60_C conditions, per the NEC (ANSI/NFPA 70) Article 336---26. If other than uncoated (no---plated), 60 or 75_C insula tion, copper wire (solid wire for 10 AWG or smaller, stranded wire for larger than 10 AWG) is used, consult applicable tables of the NEC (ANSI/NFPA70).

}Length shown is as measured 1 way along wire path between unit and service panel for voltage drop not to exceed 2%. ** Time---Delay fuse.

FLA --- Full Load Amps LRA --- Locked Rotor Amps MCA ---Minimum Circuit Amps RLA --- Rated Load Amps

NOTE: Control circuit is 24---V on all units and requires external power source. Copper wire must be used from service disconnect to unit. All motors/compressors contain internal overload protection.

Complies with 2001 requirements of ASHRAE Standards 90.1

A-WEIGHTED SOUND POWER

	STANDARD	TYPICAL OCTAVE BAND SPECTRUM (dBA, without tone adjustment)
UNIT SIZE---SERIES (VOLTAGE)	RATING
		125	250	500	1000	2000	4000	8000
	(dBA)
018---C (N)	73	58.5	62.5	67.0	67.5	65.5	62.5	53.5
024---B (N)	72	54.5	63.0	66.5	66.0	64.0	60.5	51.5
030---C (N)	73	57.0	63.5	68.0	69.0	65.0	61.0	52.5
030---B (P)	72	53.0	60.5	66.0	67.5	64.5	61.5	53.0
036---C (N)	70	54.5	62.0	63.5	64.5	63.0	60.0	51.5
036---C (P, E)	73	57.0	63.5	68.0	69.0	65.0	61.0	52.5
042---B (N, P, E)	73	55.0	60.0	64.0	67.5	61.5	60.0	55.0
048---B (N, P, E)	74	57.5	64.5	67.5	69.5	66.5	61.0	53.0
060---B (N, P, E)	74	53.5	63.0	67.5	70.0	63.5	60.0	55.5

NOTE: Tested in accordance with ARI Standard 270---95 (not listed in ARI).

CHARGING SUBCOOLING (TXV-TYPE EXPANSION DEVICE)

UNIT SIZE---SERIES (VOLTAGE)	REQUIRED SUBCOOLING _F (_C)
018---C (N)	10 (5.6)
024---B (N)	12 (6.7)
030---C (N), B (P)	12 (6.7)
036---C (N, P,E)	10 (5.6)
042---B (N, P, E)	11 (6.1)
048---B (N, P, E)	11 (6.1)
060---B (N, P, E)	12 (6.7)

223A

7