Bryant 313AAV Electrical Data, Typical Gas Pipe Arrangement, Electrical Connections

Table 7 – Electrical Data

		VOLTS			OPERATING			UNIT	MAX WIRE	MAX FUSE/
FURNACE					VOLTAGE*		MAX UNIT				MIN WIRE
		HERTZ						AMPACITY#	LENGTH}	CKT BKR{
	MODEL			(VOLTS)		(AMPS)	GAGE
		PHASE							(AMPS)	FT. (M)	(AMPS)
					MAX	MIN
045	--- 08 / 024045	115---	60---	1	127	104	8.1	10.9	34 (10)	15	14
070	--- 16 / 048070	115---	60---	1	127	104	9.5	12.6	29 (9)	15	14
090	--- 16 / 048090	115---	60---	1	127	104	10.3	13.4	27 (8)	15	14
110	--- 20 / 060110	115---	60---	1	127	104	13.1	16.9	34 (10)	20	12
135	--- 20 / 060135	115---	60---	1	127	104	13.1	16.9	34 (10)	20	12

* Permissible limits of the voltage range at which the unit operates satisfactorily.

#Unit ampacity = 125 percent of largest operating component’s full load amps plus 100 percent of all other potential operating components’ (EAC, humidifier, etc.) full load amps.

{ Time---delay type is recommended.

} Length shown is as measured 1 way along wire path between unit and service panel for maximum 2 percent voltage drop.

GAS

SUPPLY

MANUAL

SHUTOFF

VALVE (REQUIRED)

SEDIMENT TRAP

UNION

313A

A02035

Fig. 22 - Typical Gas Pipe Arrangement

ELECTRICAL CONNECTIONS

!WARNING

ELECTRICAL SHOCK HAZARD

Failure to follow this warning could result in personal injury or death.

Blower access panel door switch opens 115-v power to control. No component operation can occur. Do not bypass or close switch with panel removed.

See Fig. 25 for field wiring diagram showing typical field 115-v wiring. Check all factory and field electrical connections for tightness.

Field-supplied wiring shall conform with the limitations of 63_F (35_C) rise.

!WARNING

ELECTRICAL SHOCK AND FIRE HAZARD

Failure to follow this warning could result in personal injury, death, or property damage.

The cabinet MUST have an uninterrupted or unbroken ground according to NEC ANSI/NFPA 70-2008 and Canadian Electrical Code CSA C22.1 or local codes to minimize personal injury if an electrical fault should occur. This may consist of electrical wire, conduit approved for electrical ground or a listed, grounded power cord (where permitted by local code) when installed in accordance with existing electrical codes. Refer to the power cord manufacturer’s ratings for proper wire gauge. Do not use gas piping as an electrical ground.

21