Bryant FF1DNA, FF1DNE manual Specifications, 024005 024075 024011 030005 030075 030011

SPECIFICATIONS Continued

UNITS WITH FACTORY-INSTALLED ELECTRIC HEATERS OR CONTROLS

UNIT SIZE		024005	024075	024011		030005	030075	030011
RATINGS & PERFORMANCES
Nominal Capacity (Btuh)*		24,000	24,000	24,000		30,000	30,000	30,000
Nominal Airflow (CFM)			870				1080
Electric Heating Output (kw @240v)		5.0	7.5	11.0		5.0	7.5	11.0
Electric Heating Capacity (MBH @208/230v)		14.0/16.9	20.4/24.7	29.4/35.7		14.3/17.2	20.7/25.0	29.7/36.0
ELECTRICAL
Unit Volts-Phase (60 Hz)		208/230—1	208/230—1	208/230—1		208/230—1	208/230—1	208/230—1
Operating Voltage Range		187—253	187—253	187—253		187—253	187—253	187—253
Internal Circuit Protection					None
Full Load Amps		18.1/20.0	27.1/30.0	39.8/44.0		18.1/20.0	27.1/30.0	39.8/44.0
Minimum Ampacity for Wire Sizing		24.5/26.9	35.8/39.4	51.6/56.9		25.2/27.5	36.4/40.0	52.3/57.5
Minimum Wire Size†		10/10	8/8	6/6		10/10	8/8	6/6
Maximum Wire Length (Ft)†		112/112	117/117	122/122		112/112	117/117	125/125
Maximum Fuse Size (Amps or Ckt Bkr)		25/30	40/40	60/60		30/30	40/40	60/60
Control Transformer 24V (Va)					40
INDOOR COIL
Rows & Fins Per In.				3 & 14
Height x Width (In.)			18 x 17.8				22 x 17.8
Face Area (Sq Ft)			2.23				2.73
R-22 Refrigerant Metering Device-FF1DNA				Check-Flo-Rater
R-22 Refrigerant Metering Device-FF1DNE					TXV
Piston Number‡			63				70
Condensate Drain Connection (Pri-Sec)				3/4 FPT
INDOOR BLOWER & MOTOR
Wheel Diameter x Width (In.)				10 x 6
Filter Size—Cleanable (In.)				16 x 20 x 1
Blower Motor HP			1/5				1/3
Blower Motor Speeds & Type				2 (PSC)
Full Load Amps			1.5				2.0
OPTIONAL EQUIPMENT (P/N’s)
Louvered Wall Panel with Frame	(6 Pack)			KFBLG0106LGL
Electric Heat Package			See ‘‘Optional Field-Installed Electric Heat Packages’’ Table

* Rated in accordance with U.S. Government DOE test procedures and/or ARI Standard 210/240-94.

†Use copper wire only. Use 75°C in this application. When using non-metallic (NM) sheathed cable, wire size required should be based on that of 60°C con-

ductors, instead of wire sizes shown in table above per NEC 1996 Article 336-30. Length shown is as measured 1 way along wire path between unit and service panel for voltage drop not to exceed 2%.

‡Check outdoor unit for required piston size.

††018 Size with 11-kw heater not approved for use with heat pumps.

—5—