INSTALLATION
WARNING
IF YOU ARE DISCARDING AN OLD PPLIAN-
CE THAT HAS A LOCK OR CATCH ON THE
DOOR, YOU MUST ENSURE THAT IT IS
MADE UNUSABLE TO PREVENT YOUNG
CHILDREN BEING TRAPPED INSIDE.
DEPENDING UPON THE POSITION WHICH
YOU CHOOSE FOR YOUR APPLIANCE, YOU
MAYWISH TOREVERSETHE WAYINWHICH
THE DOOR OPENS. TO DO THIS, REFER TO
INSTRUCTIONS UNDER ÒDOOR REVER-
SALÓ.

POSITIONING

The appliance should only be installed at a loca-
tion where the ambient temperature corre-
sponds to the climate classification indicated on
the rating plate, which is located on the inside
left of the appliance.
The following table shows which ambient tempe-
rature is correct for each climate classification.
SN +10¡C to +32¡C
ST +18¡C to +38¡C
TECHNICAL SPECIFICATIONS
POWER SUPPLY VOLTAGE AND FREQUENCY 230-240 V/ 50 HZ
TOTALPOWER ABSORBED 0,6 A
AVERAGE DAILYUNITS ELECTRICITY (*) 0,36 KWH
GROSS CAPACITY 225 L
NET CAPACITY 222 L
LOCATED.
(*) This figure is based on standard test resultsin accordance with uropean Standard EN153. Actual
consumption will depend on how the appliance is used and where it is located.
The appliance should be located in a dry atmo-
sphere, out of direct sunlight and away from con-
tinuous heat and extreme temperature, e.g. not
next to a boiler or radiator or in a very cold room
e.g. an outhouse. If these temperatures are
exceeded i.e. warmer or colder, then the
appliance may not operate correctly.
For building-in and door reversal instructions
please refer to the relevant instructions on the
following pages.
Important
It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after instal-
lation.
9