10

Reversibility of the doors

The door of the appliance has been immobilized
with pins for transport.
Remove the top and bottom pins based on the
direction in which the door opens.
Warning!
Once the door has been reversed, check that
the magnetic joint adheres to the structure. If the
temperature in the room is too low (in the winter,
for example), it might not adhere perfectly.In this
case, if you do not want to wait for the joint to
resume its natural size after a given amount of
time, you can speed up the process by heating
the part with a hair dryer.
ELECTRICAL CONNECTION
WARNING
THIS APPLIANCE MUST BE EARTHED. The
manufacturer declines any liability should this
safety measure not be observed.
If the plug that is fitted to your appliance is not
suitable for your socket outlet, it must be cut off
and the appropriate plug fitted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should
be plugged into a 13amp socket in another part
of your home.
Important
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
If you fit your own plug, the colours of the wires
in the mains lead of your appliance, may not cor-
respond with the markings identifying the termi-
nals in your plug, proceed as follows:
ConnecttheGreenandtheYellow(earth) wire to
the terminal in the plug which is marked with the
letter “E” or the earth symbol , or coloured
green and yellow.
Connect the blue (neutral) wire to the terminal in
the plug which is marked with the letter “N” or
coloured black.
Connect the brown (live) wire to the terminal in
the plug which is marked with the letter “L” or
coloured red.
The plug moulded onto the lead incorporates a
fuse.
For replacement, use a 13amp BS1362 fuse.
Only ASTA or BSI approved fuses should be
used.
The plug must not be used if the fuse cover/car-
rier is lost. The cover/carrier is indicated by the
coloured insert at the base of the plug.
This appliance complies with the following
E.E.C. Directive:
-73/23 EEC of 19.2.73 (Low Voltage
Directive) and subsequent amendments.
- 87/308 of 2.6.87 (Radio Interference
Suppression) and subsequent amendments.
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent amend-
ments.
Please ensure that when the appliance is
installed it is easily accessible for the engi-
neer in the event of breakdown.