![](/images/new-backgrounds/1054724/5472411x1.webp)
•If a second stage of heat is called for, the flashing rate of HEAT increases
•If the 3rd stage of heat activates, the display will also flash "AUX " in addition to HEAT flashing.
5.7 COOL
•Use COOL mode to control your air conditioner, cooling your home.
•In COOL mode, COOL is displayed right of the set temperature.
•COOL will display solid if there is no load.
•While the 1st stage of cooling is active, COOL will flash.
•If a second stage of cooling is called for, the flashing rate of COOL increases
5.8 OFF
•Slide the MODE switch to OFF when no heating or cooling is desired. Heating and cooling will be disabled, and the set temperature side of the display will be empty.
5.9 DEFAULT PROGRAM
•As supplied from the factory, your thermostat will use its default program for temperature control. This program and all other settings may be restored to their default values via a SOFTWARE RESET. Please refer to DEFAULT TEMPERATURE PROGRAM for program times and temperatures.
5.10 HOLD
Hold is the simplest method to maintain fixed set temperatures.
•Press HOLD once to enter permanent temperature HOLD while in RUN or OVERRIDE. HOLD will be displayed above the set temperature in the display.
•Pressing this button again will toggle HOLD off and return to RUN and the programmed set temperature.
•Changing system mode or rotating the SPEED DIAL® will also cancel a HOLD.
5.11 OVERRIDE
During RUN, set temperatures may be temporarily altered from their programmed values. Immediately after a set temperature has been altered, the
•Press either the UP or DOWN key. The current modes set temperature will begin to flash.
•Adjust the set temperature as desired.
•After a few seconds, the default
•Adjust the duration in
•When the duration stops flashing, the OVERRIDE has been initiated and the Set Temperature side of the display will show
OVERRIDE.
•The adjust temperature will remain the set temperature in the current mode for the duration of the OVERRIDE. Then temperature settings return to their program values.
•OVERRIDE may be cancelled by initiating a HOLD and then canceling it, changing the position of the mode switch, or rotating the
SPEED DIAL®.
5.12 FAN MODES
•The FAN switch controls which of three fan modes your thermostat is to use. These modes are AUTO, CLEAN and ON.
5.12.1 AUTO
•AUTO mode runs the fan only to fulfill your heating and cooling requirements.
5.12.2 ON
• ON mode runs your system fan continuously.
6