14B SST Series Amplifier
Rear Panel Input / Output Connections
Fig 1
1/4” PHONE PLUG
XLR TYPE RCA PLUG
2
1 | 4 |
| 3 |
5
1. Input Select Switch.
Each SST channel gives the user the option of switching between either balanced input or single ended input.
Input Sensitivity Selection.
The optimum gain setting will depend upon the source
The UNBAL setting is used when the source is
The UNBAL and BAL+6 setting provides the most amplifier gain
The BALsetting is used when the sources output is actively balanced.
This setting with any systems where the volume control rotation is limited to the bottom half of the control or less.
The BAL setting provides an amplifier gain - 23 dB. ( 2v in = 100w @ 8 ohms.) ( noise
The noise is referenced in dB below rated output. Different input configurations result in slightly different noise readings. The above noise ratings represent minimum readings, actual readings may be better.
2. Balanced Input connector. ( Imp. 20k )
This input connector accepts standard ‘XLR’ or 1/4” TRS .
Use quality, 100% shielded cables with gold plated connectors.
3. Single Ended Input. (
This input connector accepts standard ‘RCA’ or ‘Phono’ connectors.
Use quality, 100% shielded cables with gold plated connectors.
Balanced input Vs Single ended input:
The balanced input requires a balanced
The single ended or unbalanced input is provided for
4. Level Control. (pro models only)
The level control will attenuate the input signal level from 0dB through
2