To redial the last number
You can redial a number up to 32 digits long.
1Press the Handsfree button.
2Press the Redial button.
The last number you called is redialled.
If the number is still engaged, your Converse 320 will wait for 45 seconds before repeating the procedure. This will be repeated every 45 seconds up to a maximum of 15 times or until the call is answered.
Note
Lifting the handset, pressing the Handsfree button or the Headset button again will cancel the procedure.
To adjust the ringer volume
Set the ringer volume switch on the underside of your Converse 320 to the setting you want: HI, LOW or OFF.
HI
LOW
OFF
RINGER
VOLUME
The call indicator light will flash when you have an incoming call with all 3 settings.
To
a number
This feature works in handset, handsfree and headset modes.
If the number you call is engaged, you can set your Converse 320 to dial a number repeatedly, saving you from having to continually press the Redial button.
1When you hear the engaged tone, press the Redial button.
2Replace the handset (or press the Handsfree or the Headset button - depending which mode you are in). The display shows BUSY.
Ten seconds after the handset is replaced, your Converse 320 will switch to ‘handsfree’ mode and the number is redialled.
Visual ring indicator
When you have an incoming call, the Visual ring indicator will flash in time with the ringing signal. Lift the handset to answer the call.
Message Waiting
indicator
When you have Voice Mail messages waiting, the Message Waiting indicator will flash at regular constant intervals.
Note
This feature is for Meridian switchboard users only.
To adjust the
ringer tone
Set the ringer tone switch on the underside of your Converse 320 to the setting you want: R1 for a low pitch ring or R2 for a high pitch ring.
R1
R2
RINGER
To adjust the caller’s
speech volume
During a call, you can make your caller’s voice louder.
When using Handsfree: 
Press the VOL + or VOL - button to increase or decrease the volume of
your caller’s voice.
