BT Converse 425 ~ Issue 3 ~ 2nd Edition ~ 23rd July ’03 ~ 5528

Setting up

Plan the location

Situate your Converse 425 close enough to a phone socket so that the line cord will reach.

Your Converse 425 can be wall-mounted. See Wall-mounting’,on page 20.

Note

When your batteries are within about two weeks of total exhaustion, BATT LOW will appear in the display. If you do not replace the batteries and

they become totally discharged your Converse 425 will not display anything on the screen.

1Install the batteries

The display on your Converse 425 is powered by 3 x AAA alkaline batteries.

Make sure the phone is not plugged into the phone socket. Open the battery compartment cover.

Insert batteries as shown.

2Plug your Converse 425 into the phone socket

SETTING UP

+ - +

- + -

Close the lid and replace the compartment cover.

3Check the dialling mode

Your Converse 425 should be pre-set to T-TBwhich gives you TONE dialling.

This ensures the phone will work with all modern digital exchanges.

If your phone does not work when you dial a number, try setting the dialling mode to T or P.

5

Page 6
Image 6
BT manual Setting up, Plan the location, Install the batteries, Plug your Converse 425 into the phone socket