45 Series Rotary Tiller
DRIVELINE DIMENSION - CONT'D.
7.Pull the driveli ne apart and cut 1/2 of the dimension determined in step 5 from each end. Add another ½ inch (12MM) to each cut off segment.
8.Be sure to use a hacksaw to cut 1/2 from each end of the separated shaft. Cut both the plastic tube and the metal cores.
9.Use a file to remove the burrs from the edges that were cut.
10.Assemble the two ends of the shaft.
11.Make sure that the shaft can telescope freely. If it does not, separate the two parts and inspect for burrs or cuttings on the shaft ends. Be sure it telescopes freely before installing.
12.Make sure the plastic covering shield is free to rotate on the shaft before installing on the machine.
-12 -
