
Heavy Duty Finishing Mower
HITCH ASSEMBLY INSTRUCTIONS
1.The hitch is assembled except for the two pivot bars (#69). Bolt one end of each pivot bar between the welded brackets at the back of the deck using the bolts assembled in the mower.
2.Remove the 3/4” bolt (#63) at the top of the hitch assembly. Using the same bolt, assemble with the pivot bars between the hitch weldment (#38)
CHAIN KIT ASSEMBLY
1.Drill 13/32” holes in the back lip of the deck Weldment spaced as shown on the drawing. The hole spacing should be centered across the width of the back lip.
2.With the narrow lip of the chain guard plate (#2) turned up, push an end link of a
3.A 5/8” long spacer (#6) fits between the guard plate and the rear lip on the deck. These spacers must be centered on the holes in the guard plate and the rear lip on the deck. With the spacers in place, position the chain guard assembly under the lip on the deck. Clamp on assembly to hold in place. Bolt guard plate assembly to the deck using 3/8” x 1 ½” bolts, lock washers and hex nut.
QUICK HITCH KIT INSTRUCTIONS
1.Remove the two sets of lift brackets with the lower lift pins from the mower hitch arms (#4).
2.Bolt the adaptor plates (#13) to the outside of the hitch arms welded to the deck. Turn the plates as shown in drawing. Use the ¾” x 2 ½” bolts and bushings in the 1” holes. The 5/8” x 2” bolts holding on the
3.Assemble the two quick hitch arms (#4) on the inside of the adaptor plates using the lift pins with the swivel bushings from step one at the bottom. The
8